new x10 ps561 console keeps beeping/chiming

[dragonfly1113]

every once in a while when i go to arm my ps561 with my remote control keyfob the console it self keeps chiming alot like a door bell going off, and it wont stop unless I press disarm, but than every once in a while it works like it should, any ideas as to why this is happening? im new to the forums tried searching but couldnt find anything similar to this issue.

Thanks in advance guys.

[Brian H]

Maybe a zone not reporting in and it is flagged as an error.
Are any of the Zone LEDs flashing?
Do you have more than eight zones installed?

[dragonfly1113]

I have only one zone set up its the front door magnet sensor thing running with a lamp module hooked up to a lamp.

[anthonylavado]

I have only one zone set up its the front door magnet sensor thing running with a lamp module hooked up to a lamp.

To go over what Brian said, try checking the last few pages of the manual: ftp://ftp.x10.com/pub/manuals/ds7000-om.pdf

There's a very good "Troubleshooting" section that should tell you what's up.
A few pointers from what I have learned in using the system myself:
-Make sure your door is closed before you press "Arm"
-Make sure your sensor is lining up and reporting properly (To check, set it to "Run 2" and see if it chimes when you open the door)

Let us know how it goes!