Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Billaban]

Greetings,

I have been trying to rejuvenate a couple macros that involve motion detectors and a few LM15As for garage and basement lighting.  2 of 4 LM15A's behaved properly and I was able to reprogram to the desired settings.  It looks like the other two are toast from blown bulbs or some other event  as described by many on these forums.  I make this conclusion based on screwing a unit into a lamp sitting next to my AHP setup (recently updated to current version) and the lamp lights.  I send the "all lights off" command from AHP and the light stays on  .  Both of the suspect LM15As behave the same.   I see all the expected command traffic on the activity monitor. Is this conclusion correct?  If not, suggestions would be appreciated.

 

[Brian H]

If the LM15A turns on the installed bulb as soon as power is applied. It is toast as they default to Off and be in the programming mode for thirty seconds.