Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Wierd Problem  (Read 2252 times)

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Wierd Problem
« on: September 27, 2011, 08:05:16 AM »
This just popped up.  I have 2 RR501 transceivers, one on housecode A and on on housecode F.   Yesterday the Unit F2 (an overhead fluorescent light (2 tubes) failed to accept X10 signals, AHP (3.310) cannot control it  plus the stick-a switch in the breakfast room cannot control any module on F but has reverted to housecode A.   What's going on?
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!

J.B.

  • Hero Member
  • *****
  • Helpful Post Rating: 16
  • Posts: 319
Re: Wierd Problem
« Reply #1 on: September 27, 2011, 08:10:06 AM »
The stick-a-switches will revert to HC A if they lose battery power or have low battery, just as x10 motion sensors do. Did you check the battery or try to reprogram the HC/UC?
Any chance where it is a florescent fixture the ballast or a bulb is failing and introducing noise?
Logged

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: Wierd Problem
« Reply #2 on: September 27, 2011, 02:25:52 PM »
The battery went bad, it reverted to A.  Got a new battery, reset to F (Food) and each RR501 gets only the proper codes from their SS13As.   When resetting a SS13A (Stick-a-Switch) don't work fast when changing a housecode above C.  It may take several tries to get the housecode you want. 
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.