Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Collegekid]

I recently got the Airplay X10 (modal number CM005) from my dad after he got a new tablet. Not but 5 min later my brother's fiance accidentally knocked it off the table while it was charging. Now it doesn't seem to be charging when I have it plugged in and When I try to turn it on a green LED flashes once then nothing. I checked the charger and it is still producing charge, help?

[dave w]

Not much to help with. The female side of the charging connector is likely broken. When you plug the coaxial connector in to the Airpad does it seem secure or is it loose? I thnk you can charge through the USB but it will take much, much longer. 

[Collegekid]

You are right, the female coaxel is broken, popped open the casing (i know void warenties, dont do it bla bla bla) and 2 of the connecters popped. I think i may be able to solder them back on if I can convince my IT friend to do it lol (one of the benefits of being at an university i guess) how exactly would I charge via another port?

[dave w]

I think i may be able to solder them back on if I can convince my IT friend to do it lol (one of the benefits of being at an university i guess) how exactly would I charge via another port?

Good luck - hope you can fix.

I don't have an Airpad, but believe it will also charge through the USB connection but at a MUCH slower rate (like a two day rate). Others have mentioned it on the forum.

[X10 Repair Depot]

You are right, the female coaxel is broken, popped open the casing (i know void warenties, dont do it bla bla bla) and 2 of the connecters popped. I think i may be able to solder them back on if I can convince my IT friend to do it lol (one of the benefits of being at an university i guess) how exactly would I charge via another port?

Soldering the connector will likely fix the problem if you know what you are doing and have the proper soldering equipment. Do not try to solder it using a cheap soldering iron or you will damage the board and / or connector.

The CM005 (Airpad X) will not charge through the USB port.

[dave w]

The CM005 (Airpad X) will not charge through the USB port.

Well, "There-ya-go" straight from the horses mouth.
FWIW:
Piggy backing on X10 Repair Depot advice about soldering. Hopefully your IT guy will have a temperature controlled, fine point tip, soldering iron. Also, 63/37 solder or even a small diameter silver solder http://www.radioshack.com/product/index.jsp?productId=2062717 would be a safer solder to use since it has a more narrow plastic range compared to typical 60/40 solder. So the amount of time the iron is on the board is reduced. Carrying to the extreme, brushing some liquid flux on the area helps reduce PC board damage also.