Hello everyone, I recently added a new generation X10 module to my outside lighting circuit ( XPD13-IW ) I am running the latest release of AH software 3.318, I run a macro that is triggered by an outside motion sensor ( the darkness trigger A2 ) there are 3 of the old lamp type WS467 modules assigned as A2 and the new module XPD13-IW assigned as A6 , A2 triggers the macro and turns on the A2 lights, on command 100%, 10 seconds later A6 is commanded to go to 94% absolute command ,, I have set A6 the XPD13-IW up as a LM14A 2 way lamp module, 5 minutes later I command the A2 and A6 modules to dim to 53% and 62% with a set absolute command, the old modules work great as they always have, the new XPD13 module turns on at full brightness then dims to 62% after approximately 1 minute, I have tried what was recommended in the post about dimming modules with the same result, any ideas would be appreciated, almost forgot, the software is sending extended commands and I can operate the light with the slider from the layout screen, just seems like this module has a mind of it,s own an reverts to the original dimmed setting after about a minute no matterwhat you do ...
Author
Topic: XPD13-IW Problems With Active Home (Read 2499 times)