Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[ShibaDog]

I think I'm doing everything right. Using SHP and connecting to my CM11a serial. With computer attached, I can run all the lamp modules and appliance modules, but when I try to download to the CM11a I get the error message that there is not enough space in the interface. But it shows all memory usage at 0%. How can it be full AND at 0%???

Is there a hard reset? Tried unplugging and no batteries overnight. No differrence. I cleared the memory, no difference.

Any suggestions?

[Brian H]

Smarthome Pro?
Are you using Active Home Pro with a CM11A Serial Interface?
You using the latest AHP 3.318?
Did you download any Dusk Dawn settings? If you did what resolution did you use?

I will see what I get with my CM11A and AHP.

[Brian H]

I tried getting my CM11A working with AHP 3.318 and didn't have much success.
My memory useage was showing the amount of memory being used by the dusk dawn tables.
Tried a clear interface memory function and it locked up. Also started sending a constant string of power line J Status Requests. 

Had to power cycle it before I could access it again.

Works fine with the older Active Home Program written for it many years ago.

[dhouston]

This probably will not help but I do have a link to the chief X10 programmer...

• http://www.bing.com/th?id=Aftwy3vw0L%252fmpRA300C300&w=110&h=110&c=6&qlt=80&pid=16.1

[Brian H]

Tried the CM11A with AHP 3.318.
This time I set AHP to the CM11A serial port and then closed the program.
Connected the CM11A to the AC power and started AHP. I know the CM11A sends a constant request to set its clock at power up and that may have been my problem. Or my jumping between AHP and the older AH may have put things in a bad state.
I now have the 0% memory useage and when trying a download timers and macros. Got the same error of no room.
Though when I accepted the error. The small downloading icon appeared on the bottom AHP task bar. Though my guess is nothing was happening.
Clear Interface Memory also works.
I may look at the known AHP issues thread and see if anything pops up.