AHP CM15A driver

[bkenobi]

I am using a different software for my HA system these days.  That being said, I have AHP installed on my file server and would like to run a test on it.  When I plugged the CM15A into it, the driver was set to a different one than AHP needs.  As a result, when I try to run AHP I get an error:

Code Select Expand

Error Getting X10Net Interface

I'm sure this is related to using the wrong USB driver.  Can someone point me to the correct location of the inf file that I need to use to switch over drivers?  I know it's on the system since I've switched back before, but I can't seem to remember where it was located.

[bkenobi]

Never mind.  I forgot that I stopped the X10 service to allow the other driver to install.  After setting it back to "Automatic" and starting the service, AHP starts like a champ.  That's 3 hours I won't get back.   

[Tuicemen]

  Been there!..............
Several times.

[joe s.]

Try to be philosophical - would you have cured the common cold in that same timeframe ?