Rogue Transmit Signal

[bt54]

My first floor lights have stopped working from my Palmpad (3 wall switches and a lamp module).  The switches manually work.  I'm looking at the Activity Monitor and one Light Switch on another floor is receiving a never ending flow of Receive signals.  I pulled the batteries from all of my Palmpads and that did not stop the signal.  I also cm15
cleared the memory on my CM15 and then reprogrammed it.

Signal Code is:  Date\Time    Receive    L16 (Garage Door Light)

Does anyone have any idea what is happening??

[Brian H]

Is L16 a valid X10 address being used in your system?
Do you have any X10 Coupler Repeaters in your system.
The Activity Log is showing power line or RF L16 commands?

[bt54]

Brian,
Thanks for the reply !!!
L16 is a Valid Address.  I have a repeater that I didn't think of and checked it after I made the post.  I replaced it with another repeater and the flood of signals stopped but I think the "new" repeater has problems as it is sending mixed signals.  I pressed L9 on the Palmpad and L9 & L10 were activated.  My basement (where the repeater is located) has all of the Light Switches and modules working but my First floor is still not working.  I replaced a light module and now it works.  I have two wall switches that I'm going to remove and test as they are not activating when signaled.