TM751 and CM15A

[robo]

I was troubleshooting why I was unable to
use the "switch" functionality of the AHP
GUI when using a TM751 module. It appears
from the activity monitor that the on/off
switch of the TM751 module currently sends
only line signals which the TM751
cannot "hear" or receive.

However if I use an RF remote or
Firecracker than an RF signal is sent and
the TM751 works fine.

Why does the on/off functionality of the
TM751 module  in AHP send line signals
rather than RF signals when the TM751 can
only receive RF signals? Can this be
changed?, is there a work around?

[X10 Pro]

We're aware of this and will be fixing it
soon. You can work around it by creating
macros to send RF on and off commands on the
address of the TM751.