flags won't set

[kenny]

New for today! Flags can't be set anymore!
These are critical for my macros and they
stopped working today.

Any ideas?

Kenny

[X10 Pro]

There is a problem in some circumstances
where the Status Report isn't displaying the
correct flag data. Try triggering a macro
that sets a flag, and then trigger a macro
that uses that flag as a condition -- it
should work.

[kenny]

That's exactly how I know that the flag isn't
set.  I ran a macro tht sets a flag and then
a light turned off via a macro that is
conditioned on an off signal from a motion
but only if flag 2 is off.  Status report
show flag 2 off and everything behaves as if
it really is.  The flag isn't being set.

Kenny

[X10 Pro]

Are you using the "Run Macro" button in the
software, or triggering with a remote control?

[kenny]

I originally ran the macro from the software.
I just tried it with the RF switch I usually
use and the report noted the flag as set.
That's wierd because usually when all else
fails the software button are usually the
last to fail.

Kenny

[X10 Pro]

The "Run Macro" button doesn't currently set
flags, but that will be fixed in the next update.