Please login or register.

Login with username, password and session length

Author Topic: Disarming alarm delay sound  (Read 3291 times)

pridevea

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Disarming alarm delay sound
« on: October 06, 2004, 11:53:38 PM »

Hi, Is there any way to disable the 60
second delay chime when arming the x-10?
Thank you
Logged

rm

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: Disarming alarm delay sound
« Reply #1 on: December 06, 2004, 04:37:08 PM »

not as far as i can figure out either.. i
hate that countdown, its loud and annoys me
and probably the neighbours.. one thing i
noticed is if you set the alarm via one of
the keychain remotes it doesnt count down.

Logged

joel

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 45
Re: Disarming alarm delay sound
« Reply #2 on: December 11, 2004, 05:19:55 PM »

No, the keychain doesn't cause the sound. The
countdown gives you a minute to get outside.
The keychain remote follows the idea of being
outside already, so it doesn't need to
countdown. This is bad for another member
without a keychain remote coming home because
they have no chance to disarm it. I don't
believe there is any way to disable the
countdown, you can set the switch to "MIN"
but then you have no time to get outside. The
only problem with using the keychain remote
is that from outside, you can't hear the
emitted tone telling you that the system
can't be armed because a zone is active. I
get this quite often because the sensors
report motion but the DSC 700 doesn't recieve
the "off" signal from the sensor. Which makes
me use the inside remote to ensure proper
arming. The tone is not that loud to disturb
neighbours, it's not that bad.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.