Controlling mulitple cameras with one motion sensor and VCR Commander

Started by ed, September 10, 2005, 01:12:25 PM

Previous topic - Next topic

ed

I have a surveillance system I purchased
from X10.  After playing around with it for
a few hours I have everything working but I
can't get the CR12A to automatically scan
from camera to camera.  Is this supported?
I'd like to have a motion sensor that
controls the VCR but I'd like the CR12A to
switch from camera to camera every 30
seconds or so.  Is there any way to set
this up?  Do I need anything additional?

Brian H

In the X10 Support Arae. FAQ Section. Camera
Accessiries.
The CR12a will not automatically scan the
cameras. It remembers the last one it turned
ON and then turns the next higher or lower
one ON depending on which scan button is
pushed.

SMF spam blocked by CleanTalk