Please login or register.

Login with username, password and session length

Author Topic: cm19a and ninja robotic and pantilt pro  (Read 24362 times)

asihuay

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
cm19a and ninja robotic and pantilt pro
« on: September 11, 2006, 10:10:05 AM »

Hi.
I mount one network camera on ninja robotic base , I install the pantilt pro software and then connect cm19a to my PC , OK no problem, work good from software and the remote ( up down left right ), my problem is when I move the base to another room one flour down the RF signal do not work (cm19a and remote) , I use and USB extender with 150 feet cat5 cable and connect the cm19a , this solution work only when the base and the cm19a are up-to 6 feets, I want know is exist RF booster or better solution like transceiver in order to control over the power line,  like active home pro with its power modules.
thanks in advance.
asihuay
Logged

Charles Sullivan

  • Hero Member
  • *****
  • Helpful Post Rating: 94
  • Posts: 1565
    • HEYU - X10 Automation for Linux, Unix, and Mac OSX
Re: cm19a and ninja robotic and pantilt pro
« Reply #1 on: September 11, 2006, 11:39:13 AM »

The X-10 SR731 is an RF repeater.  See http://www.x10.com/automation/sr731_s.html

Better have X-10 verify that it supports the Ninja Pan/Tilt and CM19A codes - the description doesn't specifically state that it does.

(Disclaimer: I don't own a SR731 so can't say how well it works.)

Logged
Yesterday it worked.
Today it doesn't work.
X10 on Windows is like that.

HEYU - X10 Automation for Linux, Unix, and Mac OS X     http://www.heyu.org

asihuay

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: cm19a and ninja robotic and pantilt pro
« Reply #2 on: September 11, 2006, 08:47:14 PM »

Hi Charles
Thanks for your information, at this time I buy one of this in order to extend the RF signal.
When it arrive to me and put to work I reply again in order to inform the comunity.
asihuay
Logged

asihuay

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: cm19a and ninja robotic and pantilt pro
« Reply #3 on: September 26, 2006, 09:06:52 AM »

Hi.
I use the X-10 SR731  RF repeater with my cm19a , work very good.
Thanks to Charles for the information .
asihuay
Logged

vlad47

  • Newbie
  • Helpful Post Rating: 1
  • Posts: 3
Re: cm19a and ninja robotic and pantilt pro
« Reply #4 on: July 05, 2007, 08:52:01 AM »

hi did you used x10 camwra, or any cameras what you like, i install wireless cameras, not x10 and want control pan tilt, but i do now can i use ninja, i control my vacation home by internet, but i use pc anyware.
thank
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.