🔌General Home Automation > Troubleshooting Automation Problems

KR19A Slimfire Remote Programming Discrepancies... [Updated: 2006/11/22]

<< < (5/5)

OX10:
I've just bought a new KR19A and found out the setup instruction (Choice #2) didn't work.  It's good thing I read this forum and tried out the third (newer) setup instruction:  Stay in programming mode and set up both house code and unit code then exit.  Thanks!

There's no date code on the back or is it the FCC ID?  There's also a Canada code.

slimfire:
Since google brought me here I thought I would register with a throwaway account and add a 4th way.   This applies to the previous post, my slimfire was just like this:


--- Quote ---I press and hold the top ON button
The LED immediately flickers once (transmits?)
A 3 second pause
The LED flashes once.
A 3 second pause
The LED flashes once. I assume for the default housecode "A"
--- End quote ---

Mine was like this.. Manual didn't help, 2nd way didn't help, 3rd way didn't help.  The procedure that worked for me was:

Hold down upper-left 'on' for 3 seconds.  First it flickers, then solid flash.
Tap for the house code.. I did 'F' -- 1..2..3..4..5..**6** 
Note on press #6, you have to press and HOLD.
If you did it right, it will blink-back to you the 6 solid flashes.

Now it is programmed to F.   

I believe to program the unit code you do the same sequence with the upper-left OFF button.

HA Dave:
WOW!!!! Puck, KDR, -Bill- (of gwjohns.com), Dan, Walt2, an edit by TTA.... I real trip down 2006 memory lane.

Navigation

[0] Message Index

[*] Previous page