...sometimes it causes my lights to go on then off then back on again.
Without more information about your setup, I'm not sure why this is happening.
However, your first option should be to try and get the
CM15A to be the
ONLY Transceiver. If possible, try a new location or look at enhancing the antenna's reception.
Have you verified that the PalmPad's
RF is
NOT reaching the
CM15A as opposed to the
CM15A's PLC NOT reaching your Livingroom light?
If you have to use a second Transceiver, then make sure the housecode you use is set to
NOT Transceive in the
CM15A. This will at least avoid power line collision / repeats.
Keep in mind that if you are using Macros to be triggered from the address/unit codes of the second Transceiver, then you run the risk of them being triggered via
PLC as well as
RF whenever the
CM15A does receive your PalmPad signals. This could be why your lights are acting as stated above.
If you don't want / need
AHP control of your livingroom, then make sure the second Transceiver and it's receiving modules are on their own housecode. And just make sure
AHP & the
CM15A do not have anything Modules nor Macros on that housecode (as well as not Transceiving it.)
Author
Topic: Using AHP and a wireless transciever (Read 2975 times)