Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Using flags in Conditions?  (Read 4835 times)

Walt2

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 28
  • Posts: 787
Using flags in Conditions?
« on: December 16, 2006, 10:12:58 AM »

I can see how to set and reset flags, but I also want to use them.

In the Condition Wizard in the Macro Designer, I can't seem to find a way to select them, flags, as a condition.  I mean, want to build/design a macro that will run if a certain flag is set, and not run if the flag is reset.

There must be a way to use them, otherwise, why have them?
Logged
* Sears Home Control System, Radio Shack Plug 'n Power, NuTone, Stanley LightMaker, BSR, HomeLink.
* Tecmar Device Master, CP290 (LightHouse), CM11A (AH), CM14A (AH2), CM15A (AHPro).

Puck

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 171
  • Posts: 1799
Re: Using flags in Conditions?
« Reply #1 on: December 16, 2006, 10:24:26 AM »

Go to Tools / Preferences and select the Smart Macros tab.

UNCHECK Show Smart Macro Wizard for New Macros

SELECT Smart Macros Interface: Advanced

Now when you create a new macro, select Use Conditions and you will now see the Flag Status condition (on the left) that you can drag & drop into your condition. From there you can select which flag(s) to check for and to check if they are SET or CLEARED.
Logged

Walt2

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 28
  • Posts: 787
Re: Using flags in Conditions?
« Reply #2 on: December 16, 2006, 10:31:23 AM »

Wow!  That's it!  Thanks!!!!
Logged
* Sears Home Control System, Radio Shack Plug 'n Power, NuTone, Stanley LightMaker, BSR, HomeLink.
* Tecmar Device Master, CP290 (LightHouse), CM11A (AH), CM14A (AH2), CM15A (AHPro).

TakeTheActive

  • Hero Member
  • *****
  • Helpful Post Rating: 126
  • Posts: 1047
  • Old !@#$% Tinkerer!
Re: Using flags in Conditions?
« Reply #3 on: December 16, 2006, 01:29:11 PM »

Wow!  That's it!  Thanks!!!!

Gentle Reminder: Don't forget to CLICK on "Helpful on the far left side of Puck's
"EXCELLENT :) / THOROUGH ;D / LESS THAN 12 MINUTES AFTER YOU POSTED :o"
reply. ;)

Keep in mind, we are all VOLUNTEERS here, and your thanks and appreciation is our *ONLY* reward!
8)
Logged
Low Post Count != Low Knowledge - High Post Count != High Knowledge ;)

ADVICE TO X-10 NEWBIES FROM AN X-10 OLD-TIMER
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.