cm19a and ninja robotic and pantilt pro

Started by asihuay, September 11, 2006, 10:10:05 AM

Previous topic - Next topic

asihuay

Hi.
I mount one network camera on ninja robotic base , I install the pantilt pro software and then connect cm19a to my PC , OK no problem, work good from software and the remote ( up down left right ), my problem is when I move the base to another room one flour down the RF signal do not work (cm19a and remote) , I use and USB extender with 150 feet cat5 cable and connect the cm19a , this solution work only when the base and the cm19a are up-to 6 feets, I want know is exist RF booster or better solution like transceiver in order to control over the power line,  like active home pro with its power modules.
thanks in advance.
asihuay

Charles Sullivan

The X-10 SR731 is an RF repeater.  See http://www.x10.com/automation/sr731_s.html

Better have X-10 verify that it supports the Ninja Pan/Tilt and CM19A codes - the description doesn't specifically state that it does.

(Disclaimer: I don't own a SR731 so can't say how well it works.)

Yesterday it worked.
Today it doesn't work.
X10 on Windows is like that.

HEYU - X10 Automation for Linux, Unix, and Mac OS X     http://www.heyu.org

asihuay

Hi Charles
Thanks for your information, at this time I buy one of this in order to extend the RF signal.
When it arrive to me and put to work I reply again in order to inform the comunity.
asihuay

asihuay

Hi.
I use the X-10 SR731  RF repeater with my cm19a , work very good.
Thanks to Charles for the information .
asihuay

vlad47

hi did you used x10 camwra, or any cameras what you like, i install wireless cameras, not x10 and want control pan tilt, but i do now can i use ninja, i control my vacation home by internet, but i use pc anyware.
thank

SMF spam blocked by CleanTalk