Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[RCaddict]

X10 work in my home fine except motion detectors and I want to interface my existing MDs to activate X10 devices. What is the best way to do that?

[Puck]

RCaddict: In order for you to receive help, you will need to provide more information. What type of motion sensor are you trying to interface to X10? What X10 equipment do you already have?

[RCaddict]

Oh, I have been ranting about these sensors here I almost took that knowledge for granted. 

http://www.homedepot.com/webapp/wcs/stores/servlet/ProductDisplay?storeId=10051&langId=-1&catalogId=10053&productId=100044253

I bought one of each modules,  basic transceiver, lamp, wall switch, chime and EagleEye to experiment before I brake the bank. So far everything seems to be working except Motion sensor.  My objective is to trigger X10 modules using Zenith MS. If every thing fail I thought of using Zenith lamp module output to do this if I find a X10 module that can generate X10 ID signal When powered up.

[Puck]

Oh, I have been ranting about these sensors here I almost took that knowledge for granted. 

I knew that; most regulars here at the forum will make the connection, but others (who could possibly provide a good solution) may not. 

Without knowing any of the technical details of the Zenith Motion Sensors, I can only guess that the X10 PowerFlash (PSC01) might be your best interface.

[JeffVolp]

I am somewhat familiar with the Zeneth devices.  While they are excellent sensors, and much more robust physically than the low-end product that X10 sells, they are not compatible with X10 products.

There is a X10 module - the PowerFlash PF284 - that can be activated by a contact closure or a low-voltage input.  That might provide the interface you need.

Jeff

[RCaddict]

Thanks.