Wireless receiver issues with LCDs

Started by diver84, September 11, 2007, 12:43:36 AM

Previous topic - Next topic

diver84

I have been trying for 2 days to receive the signal from my XCam 2 with the VR 31A hooked up to my LCD TV with no luck at all. I have the video and audio jacks inputed into an AV port on the LCD. I would only get slight snaps of grainy video and sound, but it would never lock in. Then I hooked up the coax cable, ran it thru the VCR, put up a PIP and got a solid video and sound. When I then swapped the PIP, nothing but blue screen. Is there something in the software or hardware that does not like to work with LCDs ???

Tuicemen

#1
The fact that you did
Quoteonly get slight snaps of grainy video and sound, but it would never lock in
suggests that the antenna wasn't aligned,bad wiring or RF interference or all three!

Be sure the antennas of both the cams and the receiver are pointed as close to directly at each other as you can!

I have no problems getting a clear picture on my LCD TV, but cheep (bad) RCA or Coax cables have been known to cause problems.
Try higher quality RCA cables and keep the receiver as far from the TV as the cables will allow! ;)

Many things can cause the RF interference do an Advance Search for "RF interference" it may turn up the culprit!
Please Read Topic:
General Forum Etiquette
Before you post!

SMF spam blocked by CleanTalk