Please login or register.

Login with username, password and session length

Author Topic: Sending Ninja commands from macro  (Read 4235 times)

teerex

  • Newbie
  • Helpful Post Rating: 1
  • Posts: 7
Sending Ninja commands from macro
« on: March 27, 2008, 10:04:18 PM »

Hello All:
        I am trying to send commands through the AHP to my Ninja to go to a particular preset at a certain
time/day of the week and stay there for x hrs. After this period, I would like to have it start sweeping. Can
this be done using some sort of macro ? I see the commands captured in the event log when using the Ninja's
remote and the "Advanced Functions" drop down in Macro Designer has an "Extended Code" step. I don't know
which codes the various pan/tilt/sweep functions map to. FYI,  I am using a non-X10 camera to record using
non-X10 capture hardware. I searched on the forum but didn't find anything relevant.

Thanks for any input/advice
Logged

teerex

  • Newbie
  • Helpful Post Rating: 1
  • Posts: 7
Re: Sending Ninja commands from macro
« Reply #1 on: March 28, 2008, 06:05:42 PM »

Thanks for the response. I have sent you e-mail to the address in your sig.

Regards
Logged

teerex

  • Newbie
  • Helpful Post Rating: 1
  • Posts: 7
Re: Sending Ninja commands from macro
« Reply #2 on: March 28, 2008, 08:11:31 PM »

I've sent you a PM

Thanks
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.