computer blue screen after close Vanguard software.

Started by Augus, February 02, 2008, 02:59:49 PM

Previous topic - Next topic

Augus

Need help,
whenever I close Vanguard software, my computer would get blue screen and some message. I have to reboot computer everytime.
1 Wireless PC Transceiver (CM19A);
1 PAN AND TILT KIT (CR14A)
4 EagleEye Motion Sensor (MS14A)
1 Vanguard Control Center Software (SW26A)
1 Small Wireless Transceiver (TM751)
1 VCR Commander II (UX23A)
1 USB Video Capture Apapter (VA11A)
1 Pan & Tilt Base (VK74A)
1 Small Video Receiver (VR36A)
2 XCam2 Instant-On Camera (XX16A)
2 NightWatch Wireless Low-Light B/W Video Camera (XX20A)

HA Dave

Quote from: Augus on February 02, 2008, 02:59:49 PM

whenever I close Vanguard software, my computer would get blue screen and some message. I have to reboot computer everytime.

Often... those messages actually are spelling out exactly what is wrong. Copying the message.... then searching (google-ing) the error can be very enlightening.
Home Automation is an always changing technology

zach1234

That's called the blue screen of death BSOID. If you have the ability to update you bios and drivers for your computer that may MAY help. Go to you computer makers site and look for a bios flash.

A BSOID is caused by Hardware not software. I probably helped you better that saying "its you imagination"  ::)

SMF spam blocked by CleanTalk