Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: computer blue screen after close Vanguard software.  (Read 11957 times)

Augus

  • Newbie
  • Helpful Post Rating: 1
  • Posts: 6
computer blue screen after close Vanguard software.
« on: February 02, 2008, 02:59:49 PM »
Need help,
whenever I close Vanguard software, my computer would get blue screen and some message. I have to reboot computer everytime.
Logged
1 Wireless PC Transceiver (CM19A);
1 PAN AND TILT KIT (CR14A)
4 EagleEye Motion Sensor (MS14A)
1 Vanguard Control Center Software (SW26A)
1 Small Wireless Transceiver (TM751)
1 VCR Commander II (UX23A)
1 USB Video Capture Apapter (VA11A)
1 Pan & Tilt Base (VK74A)
1 Small Video Receiver (VR36A)
2 XCam2 Instant-On Camera (XX16A)
2 NightWatch Wireless Low-Light B/W Video Camera (XX20A)

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: computer blue screen after close Vanguard software.
« Reply #1 on: February 02, 2008, 03:57:58 PM »
Quote from: Augus on February 02, 2008, 02:59:49 PM

whenever I close Vanguard software, my computer would get blue screen and some message. I have to reboot computer everytime.

Often... those messages actually are spelling out exactly what is wrong. Copying the message.... then searching (google-ing) the error can be very enlightening.
Logged
Home Automation is an always changing technology

zach1234

  • Guest
Re: computer blue screen after close Vanguard software.
« Reply #2 on: February 06, 2008, 08:35:27 PM »
That's called the blue screen of death BSOID. If you have the ability to update you bios and drivers for your computer that may MAY help. Go to you computer makers site and look for a bios flash.

A BSOID is caused by Hardware not software. I probably helped you better that saying "its you imagination"  ::)
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.