Remote Placement Issue.

[dsnevin]

I want to install, in a lockbox that can be opened with a digital keypad combination, the Arm/Disarm remote control (with time delay), just inside the building entry door.
The x10 SH624 remote is too large to fit a standard key lockbox.  Suggestions, please, re where to find a larger lockbox; or, any ideas re installing the remote in a secure place/container just inside a building entry door.

A very nice X10 Company modification to the keypad remote would be the addition of a switch that would allow the keypad remote to function either with, or without, a time delay to arm/disarm the system console.  (The keypad remote would easily fit inside a standard key lockbox.)

[x10dude]

I gave up on looking for a lockbox with a combination pad, so instead I chose a key-locked lockbox. When I first installed it, it worked well. however, in time (weeks), it stopped being picked up by the console.

In looking further into it, I discovered that the signal the remote sends is actually very weak and the lockbox itself shields the signal from leaving the inside of the lockbox. Since I actually mounted the remote inside the box, I can't physically take it out and point it towards the console.

The bottom line is that, if you end up putting the remote in a lockbox, watch out for the thickness and distance of the lockbox itself since you'd run into the same situation. Of course, if you get a box that's not think and it's not metal, then might as well not put the remote in a lockbox since it could easily be hijacked anyway.

BTW, my lockbox is a Honeywell "money/drawer box". I simply removed the cash/coin partitioner (only sits inside the lockbox.) It's small and the remote fits nicely into it w/out leaving too much open space (just a few inches on the sides of the remote.)

I hope this helps

[BVD]

http://www.calibex.com/serv/calibex2/buyer/OutPDir.jsp?nxtg=b1680a1c0516-1F3C351B79106A2F&search=security+lock+box&ysmwa=rRFDdq_rBScx7yVvRUlCbcw3AJ0RM9cgUWbtjSA3haDucnGhu_MlwlGyQm-B2thW

Check out this site. If they don't have it you don't need it!

Till Later,
Bob

P.S. I like the Honeywell on the first page!