Dawn/dusk feature

[caddyroger]

I'm not under standing how to set the dawn/dusk feature on the EagleEye sensor. Could some help in setting this up in plain simple steps.

[PajamaGuy]

This is for the HawkEye, but the EagleEye setup is the same.

To set whether you want the MS13A to transmit every time it sees motion or only at night:
Press the Unit button once. The red LED flashes.
Press and hold the House button. The green LED turns on. 3 seconds later the MS13A will report its dusk/dawn
setting as follows:
The red LED will blink once if the MS13A is set to detect motion at all times.
The red LED will blink twice if the MS13A is set to detect motion only when it’s dark.
To change this release and press the House button once for operation at all times, or twice for operation only at
night.
Hold the button for 3 seconds on your last press. The red LED will then report the setting with one or two blinks.