Please login or register.

Login with username, password and session length

Author Topic: Floodcam issue  (Read 5037 times)

JLudwig

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Floodcam issue
« on: June 24, 2008, 09:33:31 AM »

Hi , I was hoping someone could give me some help.
3 floodcams, 1 mounted 1 temp mounted, ( 1 still in box) I have the cams  set to manual, the issue is  when I reboot the system, the cams operate fine ....walk in front of 1, picks up motion, can see video, walk in front of cam 2 , changes to cam 2, can see video, works great. when I use the scan cam remote, I can see video, press 2 can see 2, press 3 can see 3. now heres where it gets a bit odd.....after using remote....it won't go back into auto mode, unless I power off then back on cams, if I walk in front cam 2 .....it will go to blank screen.......walk in front of cam 3....same,  blank....seems like no video input, seems like it is not turning cam on and off properly
cams set to A-2 and A-3
Cam channel set to A
scancam remote set to A
tm751 set to A
Ideas?
Thanks in advance
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.