Topic: conection between interface and light (Read 2414 times)

micro00 · « **on:** September 17, 2008, 04:16:36 PM »

I am requesting help???

I have installed ahp on my computer...visa operating system...computer interface talks with tramsmitter...transmitter lights up living room lights OK...bathroom light OK...
but then it will not light up bedroom light...changed SW 467 from bathroom to bed room still no good...works with remote ..can anyone help.. please send me an email..
address is .

Dan Lawrence · « **Reply #1 on:** September 17, 2008, 06:06:47 PM »

Please post the addresses of the modules you are trying to control from AHP. If your remote can address them, then AHP should be able to. As a test, use the remote while AHP is open (sit at the PC) and see if the status in AHP reflex's the status of the module in AHP.

Brian H · « **Reply #2 on:** September 17, 2008, 07:05:06 PM »

Are you using the APH CM15A as your receiver for the Remote or do you have an additional Tranceiver?

News:

Author Topic: conection between interface and light (Read 2414 times)

micro00

conection between interface and light

Dan Lawrence

Re: conection between interface and light

Brian H

Re: conection between interface and light