My problem is, I started out with the latest version, on a new computer (lost prior software, so I only have the latest copy).
I'm just trying to fix this flashing problem (NO, I'm not the flasher ... I'm the flashee!). Seems my macros work fine for a while, then go haywire every now and then.
EE sensor is set to ON command macro -> Check flag 2, if clear, raise lights 30%, SET flag 2 ...
EE sensor is on 24 hr motion, so it keeps firing ON command during motion, but macro fails flag clear check, so is ignored.
EE sensor eventually stops detecting motion, does delay, 4 minutes, sends OFF command ...
EE sensor is set to OFF command macro -> If flag 2 SET, then dim lights 30%, CLEAR flag 2.
Now what started happening is the ON command is ignoring the flag state sometimes, to wit, the EE ON command raises lights 30%, then again, then again and THEN, it dims to 0%, then raises lights to 100% then back to 0% and so on. It's a cool effect, but kind of confuses my guests :-)
I reloading the unit and all the basic stuff, so does this behavior sound like a VERSION problem soluble by downgrading?
Thanks in advance!!