Topic: An X10 command to IR command Transceiver (Read 12033 times)

Walt2 · « **on:** February 21, 2009, 07:59:22 AM »

Basically, a "box", possibly some combination of a PowerMid with a built-in learning remote, that accepts standard X10 powerline commands, and in response, transmits a learned IR command. For example, it receives the X10 powerline command of "dim up", and in response, it transmits a learned IR command of "volume up". The X10 command of "off" would cause the IR command "power off". Etc.

Tuicemen · « **Reply #1 on:** February 21, 2009, 09:29:43 AM »

This is basically what I'm working on right now!

Read Hide that VCR Commander
Only difference is it uses RF signals now. But with a CM15A you could intercept X10 PLC or even a x10 motion trigger and send the RF signal!

I'm Hoping to have something available by end of next week!

HA Dave · « **Reply #2 on:** February 21, 2009, 12:27:51 PM »

Quote from: Walt2 on February 21, 2009, 07:59:22 AM

Basically, a "box", possibly some combination of a PowerMid with a built-in learning remote, that accepts standard X10 powerline commands, and in response, transmits a learned IR command. For example, it receives the X10 powerline command of "dim up", and in response, it transmits a learned IR command of "volume up". The X10 command of "off" would cause the IR command "power off". Etc.

I have that now!!!

Bill added IR to BVC sometime ago. However I just recently found an app for it.. to turn on and off a small TV and display camera views (automatically). I use the USB-UIRT to flash a PowerMid-like device (different brand) and its mate (upstairs) controls the little TV. The PowerMid-like device faces the entertainment system so I can later add more functions.

Tuicemen · « **Reply #3 on:** February 24, 2009, 06:02:46 PM »

Just to update you Walt2!
I now have this working and not only can I send IR signal from a x10 one but I can send several IR signals from one X10 signal
As an example A4 On sends via the VCR commander/Powermid combo (pictured in previous post) sends the IR signal to turn on my TV,
change the TV channel to 03, then turns on my VCR, then starts recording!
I'm Debugging now so I'll release it soon!

Best part is most of us have the hardware laying in a box of unused X10 stuff

News:

Author Topic: An X10 command to IR command Transceiver (Read 12033 times)

Walt2

An X10 command to IR command Transceiver

Tuicemen

Re: An X10 command to IR command Transceiver

HA Dave

Re: An X10 command to IR command Transceiver

Tuicemen

Re: An X10 command to IR command Transceiver