Console DS7000 chime ding, ding, ding... after arming with R/C SH624

[Buzz]

I am a new user. I am just installing the system, and after I armed the console, it is continually chiming. Such chiming does not stop by pressing and holding bypass, and no zone led indicator flash. I followed the instructions provided by the troubleshooting guide, but did not work. Can somebody please help me?

[Kramer Chins]

Are you arming the system via the console or with a remote?

If you are arming it from the Console itself it will chime (ding,ding,ding) for 1 minute and then "ARM".

If you get a Ding,Dong,Ding,Dong chime then you have a sensor (door,window) open. But the zone light should be on.

With the system on Run 1 hit the "Bypass" button and make sure NO lights are on.....

Also make sure before you arm your system you have it either on Run 1 or Run 2, alot of times we forget and leave it on "Install"

[Buzz]

Thank you Kramer Chins for your kind answer,

If I arm the console by directly pressing arm in the console, it does as you wrote: the console chime (ding,ding,ding) for 1 minute and then armed, then functioning smoothly. The problem appears when the console is armed with the remote control SH624. If I press arm from this remote control, the console just keep chiming ding,ding,ding permanently without arming. In that chiming situation, either in Run 1 or 2, the Bypass button does not stop the chiming. Moreover, during the chiming no light are on.

[Buzz]

OK, I think I found the problem. If the delay in the remote control is set max, once armed, the console will ding, ding, ding for a minute before getting armed. I think it would be helpful to provide this information in the insert sheet that come with the remote.

[Kramer Chins]

OK, I think I found the problem. If the delay in the remote control is set max, once armed, the console will ding, ding, ding for a minute before getting armed. I think it would be helpful to provide this information in the insert sheet that come with the remote.

Yes their information sheets leave a lot to be desired..................

Just glad they have a place like this to find answers! The guys on here have saved my butt and X10 investment many times over

[kyle99]

If you are getting a constant 'ding-ding-ding-......rather than a 'ding-dong'......check to make sure your settings all 'agree' and are set the same between your remotes and sensors as far as min and max delay settings.....