Promblems with Vanguard setup

Started by kphigh, May 31, 2009, 10:08:50 AM

Previous topic - Next topic

suesloan

Make sure you used the Ninja  power supply and not the camera power supply. They are different!

Also, I found a bad electrical circuit in my house was killing all my cameras yesterday. A light in one room was flickering. I found its circuit breaker and turned it off. Cameras all back to OK now.

Sue

kphigh

Hi Sue,

There was only 1 power supply with my Ninja.. the camera plugs into the tilt and pan base so I think I'm ok there..   I used to have the Home Automation on my lights until I switched over to CF lights so I think the wiring should be ok, but I'll try a couple of different outlets and see if that helps...

thanks for your help..

kevin


kphigh

I tried Sue's suggestion and I also re-install the software and still nothing.   Any other ideas?  Maybe I should just send the whole system back...   :(

kphigh

Tried one more time.  removed and installed all software, disconnected the wireless router and 5.4ghz phone and still no go.. quess I'll be returning everything tomorrow   :(

SMF spam blocked by CleanTalk