Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Using X10 for a non-mains powered switch  (Read 2549 times)

sinkers

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Using X10 for a non-mains powered switch
« on: August 24, 2009, 03:02:51 AM »
I have recently installed a new gas heater that has a wall switch that simply turns on a valve to allow the gas to flow through which is then lit by a pilot light.

I want to automate this with X10 but don't want to run mains power through the heater as a result.

Does anyone know of a solution for this? Something that can simply flick on / off a contact switch would be perfect but I haven't been able to find anything obvious for doing this.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: Using X10 for a non-mains powered switch
« Reply #1 on: August 24, 2009, 06:04:18 AM »
Is the valve in a control voltage circuit? Like a 24 volt valve or a line voltage rated valve?

Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.