Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[cj4331]

Can't seem to figure out which way to turn the sensitivity adjustment on the top of my active eye to get it to turn the lights on earlier at night/off later in the morning--I guess you'd say this would be less sensitive to sun light as it would require more sun light to get it to recognize it was day.  Would I turn it all the way clockwise or counter clockwise?  I didn't get the instructions with the unit--it was given to me second hand.

[ITguy]

CJ4331,

You can probably download the manual for your sensor at:
http://kbase.x10.com/wiki/Motion_Sensors

I'm not absolutely certain which model you have (look for a model number on the back or inside the battery compartment), but on most of the ones I've seen, that knob on the top controls the "off delay" timer instead of the sensitivity.

Hope that helps.

ITguy

[cj4331]

It's the ActiveEye (MS16A) and the instructions I've found on the x10 wiki don't mention the adjustment on the top.

[Puck]

As ITguy has mentioned, the top control is for the off delay timer; there is no control for the light sensitivity.

[davideinmd]

Furthermore, the ActiveEye needs to be programmed to use either the digital delay or the analog delay (top adjustment dial). My 2 cents. 

[cj4331]

OK but that's not how I took it from the motion sensor comparison page http://kbase.x10.com/wiki/Comparison_of_All_Motion_Sensors
I'm confused on what it means by Dusk/Dawn Detection--variable for the MS16A.

[Puck]

OK but that's not how I took it from the motion sensor comparison page http://kbase.x10.com/wiki/Comparison_of_All_Motion_Sensors
I'm confused on what it means by Dusk/Dawn Detection--variable for the MS16A.

I think the term "variable" in this case was a poor word choice. The MS16A dusk/dawn is different from all the other models because it can be disabled (variable???)... different wording would have been less ambiguous.

[cj4331]

That sucks.     I wonder why they don't mention the adjustment dial on the top in the manual.

[dave w]

That sucks.     I wonder why they don't mention the adjustment dial on the top in the manual.

From the manual :
"To change the delay after motion is detected before an OFF code is transmitted:
Press the House/On button once. The red light flashes. Then, (within 3 seconds) press and hold the Unit/Off
button. The green light turns on. 3 seconds later the red light reports its delay setting as follows:
1 blink for Analog setting, i.e. the setting on the dial on the top of the unit...... "

X10's manuals make you do heavy reading between the lines.

[cj4331]

Yup, missed that--thanks.