Wireless Camera System ussing PC

[TheMooser]

When I hook up 1 camera it is fine. When I try to hook up another camera it overrides the 1st one. The 2nd camera shows up on the Vanguard on Camera 1 screen & camera 2 screen. I have both camera set on A1 & A2, and also the video receiver on A. Is there something else to hookup or any ideas....thanks

[Brian H]

Only one camera can be On at at a time. What else did you get with the kit?
The cameras power supplies with the dials. Use groups of four. Same House Code and Units 1-4;5-8;9-12 and 13-16. Turn one in the group On the others go Off. The power line X10 signal is what controls them.
What module did you get for the PC?
Did you get a TM751 Tranceiver also? If so it has to be plug in and set to House Code A. Since that is what House Code you have chosen to use.

[TheMooser]

After plugging in the TM751 still can not switch between A1 & A2 in vanguard ......any thoughts