Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Multiple Cameras  (Read 5798 times)

TheMooser

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 7
Multiple Cameras
« on: December 01, 2009, 07:59:59 PM »
Do you have to unplug a camera to get the other camera to show up on the PC?
Logged

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: Multiple Cameras
« Reply #1 on: December 01, 2009, 08:24:54 PM »
Quote from: TheMooser on December 01, 2009, 07:59:59 PM
Do you have to unplug a camera to get the other camera to show up on the PC?

It would be my guess that you've already found out that works. But there is a much easier way. The cameras work in "groups-of-four". That means if you were to set the cameras in say A1 through A4 (or 4-8, or 8-12, or 12-16) turn ON a camera in the group will cause the other cameras in that group to turn Off. It's all in the directions.
Logged
Home Automation is an always changing technology

TheMooser

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 7
Re: Multiple Cameras
« Reply #2 on: December 10, 2009, 07:37:49 PM »
yes, but i can change them manually on the cr13a and it changes on vanguard....but change change them manually on vanguard, it stays in the same camera even when I change the camera # on vanguard
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: Multiple Cameras
« Reply #3 on: December 10, 2009, 07:46:24 PM »
When first powered on. The camera defaults to On so more than one could be on until one is selected with the CR13A. As you have found out. Also since you can select then manually with the CR13A you have them addressed in a proper group.
I have no Vanguard experiences but I am sure other will have more help for you.
Logged

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: Multiple Cameras
« Reply #4 on: December 11, 2009, 06:52:11 AM »
Quote from: TheMooser on December 10, 2009, 07:37:49 PM
yes, but i can change them manually on the cr13a and it changes on vanguard....but change change them manually on vanguard, it stays in the same camera even when I change the camera # on vanguard

So that would mean.... the cameras aren't getting a signal from the computer. Are you using a CM19A.. that maybe you could put up a little higher?
Logged
Home Automation is an always changing technology
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.