Please login or register.

Login with username, password and session length

Author Topic: What is needed to add cams for AHP  (Read 7576 times)

Aaron1312042

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 14
What is needed to add cams for AHP
« on: April 25, 2010, 03:53:15 PM »

I know I need iWatch for AHP but am confused as to what hardware is needed for a multi-cam setup.

Here is what I think I need:

VR36A
VA11A

Am I correct? Thanks
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13263
Re: What is needed to add cams for AHP
« Reply #1 on: April 25, 2010, 06:50:00 PM »

The VR36 will receive the video from the cameras.
The VA12A [VA11A supreceeded by VA12A] will take the video from the receiver and input it into the computer.

You will still need a way to switch the cameras on and off as only one can be on at a time. By sending an X10 on and off power line signal to the cameras power supplies.
I believe the  UR19A interface that send RF to a TM751 to control the supplies are used.

There are some install instructions here:
http://www.x10.com/instructions/
http://kbase.x10.com/wiki/IWatchOut
Logged

Aaron1312042

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 14
Re: What is needed to add cams for AHP
« Reply #2 on: April 25, 2010, 08:15:31 PM »

Or Mortion Detectors for switching. Thanks very much for the info.  ;D
« Last Edit: April 26, 2010, 06:05:10 AM by Aaron1312042 »
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.