Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[albertf]

I have had an X10 kit sitting around for a long time and tried to get it setup on a mac.  Several queries:

1.  I have an old X10 CM11A controller hooked up to a Mac Pro with a Keyspan serial adapter. I'm running the demo version of Thinking Home.  A simple macro will turn on the light to a Lamp Module ML465 (HD-465) for lights on the same floor of a single family house however it doesn't work on the next level of the house.  Could this be a wiring problem or can it be addressed in the software?  I'm hesitant to get a newer kit if it won't work in house wiring?

2.  What's the most reliable software to run x10 macros on a mac?

thanks

[Brian H]

Very well could be a power line signal problem.
Noise, signal sucker or on the homes other phase.
Few helpful sites for troubleshooting and explanations.
http://jvde.us/x10_troubleshooting.htm
http://www.act-solutions.com/PCC/uncle.htm

[dave w]

2.  What's the most reliable software to run x10 macros on a mac?
thanks

Not sure what you mean by "most reliable". The software does not determine how well the X10 signal probagates throughout your home.

That said; "Xtension" from Sand Hill Engineering (www.shed.com) is pretty good. I'm pretty sure they have a trial verision and also sure it will interface with CM11, CM15 and several other interfaces.