Please login or register.

Login with username, password and session length

Author Topic: Solar Powered Motion Sensor (MS14A)  (Read 17167 times)

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Solar Powered Motion Sensor (MS14A)
« on: April 20, 2010, 02:03:28 PM »

I am not sure of the usefullness of a Solar Powered Motion Sensor. But I do believe this is a project that needed to be done. Or... I just have way too much free time.


The amazing thing about this project was it was simple enough a five year old could do it... and setup was less than five minutes. Gosh you gotta love this X10 stuff.

As can be seen by the images (attached) I merely tapped the solar lights batteries at the + and - and attached the wires to the same on the sensor. The solar light I used has a off switch for the LED light... otherwise I would have needed to clip a wire to the bulb to shut the light part off. After all... the idea is to use the solar power to power the motion sensor... not drain the batteries on a light. To complete the project I mounted both the solar cell and motion sensor on a board.

« Last Edit: April 20, 2010, 10:10:43 PM by Dave_x10_L »
Logged
Home Automation is an always changing technology

GMAN

  • Sr. Member
  • ****
  • Helpful Post Rating: 3
  • Posts: 90
Re: Solar Powered Motion Sensor (MS14A)
« Reply #1 on: April 27, 2010, 02:57:56 PM »

Thank you Dave! Gotta helpful from me... I think I can run with this.  Two fold.  My rear yard sensors kept false triggering. It was driving me nuts. I ended up fashioning 'sun visors' (which I'm not real proud of) to combat it.  Your craftsmanship has sparked  an  -:)   G.
« Last Edit: April 27, 2010, 08:34:20 PM by GMAN »
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13295
Re: Solar Powered Motion Sensor (MS14A)
« Reply #2 on: April 27, 2010, 06:04:43 PM »

 #:)   Nice mod and write up.
I also gave you a helpful.
Logged

GMAN

  • Sr. Member
  • ****
  • Helpful Post Rating: 3
  • Posts: 90
Re: Solar Powered Motion Sensor (MS14A)
« Reply #3 on: May 03, 2010, 11:12:51 AM »

Just checking in. I found where to get those Solar Lights and they should arrive in about a week. Dave, how are the sensor(s) working? Just wondering because they will be just slightly under powered. 2.4v vs. 3.0v The rechargeable batts @1.2 volts per as opposed to 1.5 volts per (Alkalines) we would normally use.    G.
Logged

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: Solar Powered Motion Sensor (MS14A)
« Reply #4 on: May 03, 2010, 06:21:21 PM »

Dave, how are the sensor(s) working?

Mine worked fine. I no longer have it in service. But it had no issues with power (or any other issues).
Logged
Home Automation is an always changing technology

everydayflyer

  • Hero Member
  • *****
  • Helpful Post Rating: 5
  • Posts: 190
Re: Solar Powered Motion Sensor (MS14A)
« Reply #5 on: May 03, 2010, 09:10:12 PM »

Quote
Just wondering because they will be just slightly under powered. 2.4v vs. 3.0v The rechargeable batts @1.2 volts per as opposed to 1.5 volts per (Alkalines) we would normally use.    G.

Fresh alkies are in fact 1.6 ea. or 3.2 for the pair. Freshly charged Nicad or NiMH are closer to 1.45 or 2.9 but drop to around 1.4 in a day or so after charging. Sanyo Eneloops which have been in a Door /Window Sensor for three weeks still measure 1.32ea.  under load .  I use Sanyo Eneloops in all of my X-10 units except for one which I am using a single LiFePO4 (3.3volts)cell in.

Battery test data here

http://forums.x10.com/index.php?topic=20224.msg114130#msg114130

FYI  I have checked and could not tell any difference in range between 2.6 and 3.3 volts.
« Last Edit: May 03, 2010, 09:20:15 PM by everydayflyer »
Logged

GMAN

  • Sr. Member
  • ****
  • Helpful Post Rating: 3
  • Posts: 90
Re: Solar Powered Motion Sensor (MS14A)
« Reply #6 on: May 05, 2010, 01:15:37 PM »

Thank you for the info and good read fellow RC enthusiast!     My son and I are ground based RC'rz.   
Logged

idbl_fanatic

  • Hero Member
  • *****
  • Helpful Post Rating: 1
  • Posts: 188
Re: Solar Powered Motion Sensor (MS14A)
« Reply #7 on: August 17, 2010, 03:47:59 PM »

I See this is a rather older post, however, I was looking to do this, but have it plug in, so I don't have to keep replacing the batteries. Any ideas?
Logged

bitman

  • Hero Member
  • *****
  • Helpful Post Rating: 9
  • Posts: 597
Re: Solar Powered Motion Sensor (MS14A)
« Reply #8 on: August 17, 2010, 06:10:37 PM »

Alrighty then! and a helpful from me too!

 >!
Logged
Long live X10! - Because I just like it is all.....

dave w

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 139
  • Posts: 6116
Re: Solar Powered Motion Sensor (MS14A)
« Reply #9 on: August 17, 2010, 06:25:35 PM »

I See this is a rather older post, however, I was looking to do this, but have it plug in, so I don't have to keep replacing the batteries. Any ideas?
Daves solar powered motion sensor used rechargable batteries so he does not replace batteries in the unit (until they finally fail of old age).

However if you are asking for an indoor application, use rechargeable AAA batteries and connect a 3V DC power supply to the motion sensor battery terminals - watch the polarity or you will damage the motion sensor and batteries. It must be a regulated 3V DC supply, otherwise you will have to use some form of current limiting to avoid over charging the batteries. A switching power supply such as the link below would work well (and at 3 bucks is pretty hard to pass up). A switching supply has very precise output and three volts will "float" the batteries slightly above their terminal voltage, so you shouldn't need current limiting (I use a 3V Gameboy adaptor without any limiting). You could put a female coaxial connector on the motion sensor, or just cut the plug off the power supply and hard wire it (solder it).

http://cgi.ebay.com/AC-100V-240V-Converter-Adapter-DC-3V-1A-Power-Supply-US-/260641800510?pt=LH_DefaultDomain_0
« Last Edit: August 17, 2010, 06:29:42 PM by dave w »
Logged
"This aftershave makes me look fat"
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.