Solved: Switch shows on in AHP, but brightness is zero percent

[peg-leg]

Solved: Dummy me had unchecked Transceive house code A in the AHP hardware config menu.

I'm seeing an intermittent problem with my hr12a remote and AHP.  I've noticed at times certain lights won't turn on while others will.  I've been thinking this was a signal problem caused by some type of interferance.  Generally if I wait 30 minutes to an hour, the problem resolves itself.

Tonight the problem happened again so I I decided to monitor what was occuring by viewing the switch status in AHP.  When I press button one on my hr12a, switch A1 flips "on", but the brightness level stays at zero percent.  I checked my preferences and "issue on in place of brightness" is selected.

My switches are ws467's and ws4777's, all labeled as lm14a's to solve the compatablity problem with AHP.  I'm using ver 3.228 of AHP.

Any ideas as to what's causing my problem?

Thanks.

[Dan Lawrence]

Did you ever get your problem solved?

[peg-leg]

Yes.  Thanks for checking.