Please login or register.

Login with username, password and session length

Author Topic: Two Socket Rockets and Two Sensors Setup  (Read 2557 times)

lee911

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 28
Two Socket Rockets and Two Sensors Setup
« on: October 25, 2010, 08:24:41 PM »

I have one Socket Rocket (RLM20) that is associated with an Eagle Sensor (MS14A) and both are coded as A1. I then have a Transceiver (RTM75) that is on House Code A. It works fine with no macros or timers associated. I now want to install a second RLM20 and MS14A on the same House Code (A), but have them work indapendently of each other as they are in two different closets. When I code the new ones as A2, then both Socket Rockets come on when either Sensor is triggered. I don't want this to happen. Should I then code the new ones as C1 (most other stuff in the house is on B). What about a Transceiver? Does the Socket Rocket and Eagle Eye Sensor even need it?

Look forward to the help!!
Logged

-Bill- (of wgjohns.com)

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 81
  • Posts: 1340
  • He's just this guy. You know?
    • wgjohns.com
Re: Two Socket Rockets and Two Sensors Setup
« Reply #1 on: October 25, 2010, 09:23:16 PM »

lee911,

Code the second set to A3.

The eagle eye has a light sensor in it that is set to the coded address +1.  Which means each take up two addresses like A1 + 1 = A2.

I am assuming you're sure you've programmed the Socket Rocket addresses correctly too.   ;)
 >!
« Last Edit: October 25, 2010, 09:25:10 PM by -Bill- (of wgjohns.com) »
Logged
-Bill- (of wgjohns.com)
bill@wgjohns.com

In the real world, the only constant is change.

When I'm online you can find me in the Home Automation Chat Room!

lee911

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 28
Re: Two Socket Rockets and Two Sensors Setup
« Reply #2 on: October 26, 2010, 12:37:18 AM »

lee911,

Code the second set to A3.

The eagle eye has a light sensor in it that is set to the coded address +1.  Which means each take up two addresses like A1 + 1 = A2.

I am assuming you're sure you've programmed the Socket Rocket addresses correctly too.   ;)
 >!

I will try the A3 settings.

I'm not 100% confident I have the Socket Rocket coded properly. I've followed the instructions, but not sure if it worked or not.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.