Topic: module needs power cycle every few days (Read 2085 times)

gator.bigfoot · « **on:** November 06, 2010, 05:01:58 PM »

I have an eagle eye motion sensor running a macro. The macro turns on lights (XPS3). This works for a few days and then stops working. I do a power cycle on the module and voila everything works again for the next few days. Any ideas??

Thanks,
Walter

Brandt · « **Reply #1 on:** November 06, 2010, 06:27:45 PM »

Which module?

Brian H · « **Reply #2 on:** November 06, 2010, 06:44:39 PM »

Brandt, XPS3 is a relay type wall switch by X10Pro.

Can you control the XPS3 with direct commands from the CM15s screen when it is unresponsive?

Brandt · « **Reply #3 on:** November 06, 2010, 06:55:53 PM »

Well he mentioned scripts so he may gave been referring to an AHP controller module.

Brian H · « **Reply #4 on:** November 06, 2010, 06:56:47 PM »

Could be. Clarification from OP will help.

gator.bigfoot · « **Reply #5 on:** November 06, 2010, 07:29:14 PM »

Yes the XPS3 needs the power cycle.
I cannot control the module from AHP until I cycle the power. Then it works for a few days and then it happens again. It does turn on and off from its own control just not from AHP.

News:

Author Topic: module needs power cycle every few days (Read 2085 times)

gator.bigfoot

module needs power cycle every few days

Brandt

Re: module needs power cycle every few days

Brian H

Re: module needs power cycle every few days

Brandt

Re: module needs power cycle every few days

Brian H

Re: module needs power cycle every few days

gator.bigfoot

Re: module needs power cycle every few days