Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: DS10A Disappears from AHP  (Read 2878 times)

mjshort

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
DS10A Disappears from AHP
« on: November 17, 2010, 02:39:49 PM »
I have a macro where my front door sensor (DS10A) is triggered, the porch lights turn off 3 minutes later. It seems to work occasionally (especially when my PC is on). But it disappears from AHP. I look in the logs and it says signal from unknown source. If I reinstall it, it seems to work, but when the PC is powered off, it loses it.  Any suggestions?

Thanks.
Logged

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: DS10A Disappears from AHP
« Reply #1 on: November 17, 2010, 06:01:38 PM »
How can a DS10 disappear from AHP when you can't add it to AHP?   It's not listed in AHP, perhaps on the add-ons.
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!

J.B.

  • Hero Member
  • *****
  • Helpful Post Rating: 16
  • Posts: 319
Re: DS10A Disappears from AHP
« Reply #2 on: November 17, 2010, 06:06:55 PM »
The DS10A sensors are available in AHP with the OnAlert plug-in.
As far as I know, you cannot use a security sensor to trigger a macro unless it is run from the computer.
This would explain why it does not trigger when your AHP computer is off.
Logged

beelocks

  • Hero Member
  • *****
  • Helpful Post Rating: 9
  • Posts: 250
Re: DS10A Disappears from AHP
« Reply #3 on: November 17, 2010, 06:52:25 PM »
What JB said.
The PC absolutely must be on to process the DS10A signal.
Also remember to save your files before you exit AHP.
Logged
Although my explanations may not be exactly clear, I do hope for slightly less cloudy.
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.