Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Frank3d]

The OnAlert page is to large for my iPhone4 screen. Only once was it the correct screen size now its about twice the size it should be. Also I have had no luck arming or disarming my DS7000. AHP activity monitor does not show any commands from my iPhone for arm or disarm. I have set up AHP per all suggestions on previous posts. AHP macros work fine arming or disarming the DS7000.

[anthonylavado]

@frank3d:
1) Try double tapping the screen when you have it loaded. That is the ubiersal zoom in/zoom out gesture on an iPhone.
2) Put your Security Console into Install mode and then press Arm/Disarm using OnAlert Mobile. This should make it register, just like a remote.

[Frank3d]

@frank3d:
1) Try double tapping the screen when you have it loaded. That is the ubiersal zoom in/zoom out gesture on an iPhone.
2) Put your Security Console into Install mode and then press Arm/Disarm using OnAlert Mobile. This should make it register, just like a remote.

anthonylavado,
Tried the double tap and nothing changes. It seems no mater where I tap even once on the screen one of the OnAlert Mobile functions light up momentarily.
Concerning the Arm/Disarm problem for info I am using the CM19A with an outside antenna cut for 310Mhz not the CM15A. I did register a KR10A with the DS7000 through AHP and it will arm/disarm using a macro just fine. What Im looking for before I register OnAlert mobile with the DS7000 is the red led blinking on the CM19A indicating that its trying to send a RF command to the DS7000 but the LED never blinks like it does for the KR10A macro in AHP. Also in the AHP activity monitor log nothing shows when using OnAlert Mobile with my iPhone.
Also the OnAlert Mobile page loads on my iPhone even with the AHP PC turnd off, should it ?
 
12/28/10
I gave up trying to use OnAlertMobile with my iPhone4. I can do pretty much the same using ActivePhone which I have not got around to installing yet.