Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[signguy321]

I am a newbie and am trying to control a light using a ws467 wall switch and a ss13a slimline switch.  After installation and setting the house and unit codes, I push the button on the slimline switch and nothing.  I push the button on the slimline switch and it works flawlessly.  So I checked the codes on the slimline switch and they are set corectly as well.  Any Ideas??

Thanks

[Brandt]

do you have a wireless transceiver? TM751...RR501

[signguy321]

No I don't i thought I had all I needed.

[HA Dave]

X10 technology uses both RF (Radio Frequency) and PLC (PowerLine Commands). The PLC is sorta-like a radio signal sent on the power/electric line. And can only be detected/read/heard by X10 devices (intended to detect and use the signal) that are connected to your house wiring.

Your wall switch (WS467) uses (reads/hears) the PLC's.

While the slimline switch (SS13A) only sends a RF signal. You need a device (like the TM751 or RR501) to transceive (or receive and convert) the RF to PLC.

[signguy321]

Thanks alot, that makes sense

[signguy321]

OK I just got my TM751 and plugged it in and still nothing..........what gives

The house codes are the same and I am sure the remote is programmed right

[HA Dave]

OK I just got my TM751 and plugged it in and still nothing..........what gives

Homes have two phases... two 110-120 volt lines. When ran together that's how we get 220-240 for AC, Stoves, and Clothes dryers. It is likely your TM751 is on a different phase than your WS467. Try the TM751 in some different places.

[signguy321]

Well I had things working for a while and now not so much.  I moved the 751 around to several locations and have the same problem.  After a little bit of looking I figured out the 751 is on the same circuit as the modules I am trying to control.  I am stumped now.  Any other Ideas?

Thanks

[HA Dave]

.... Any other Ideas?

The slimline switch doesn't have much range... you should hear the TM751 "Click" when it receives the signal on the [unit number] 1 of the house address your using. If it doesn't it is an RF [likely range] problem. You could try putting a new battery if the slimline switch. I think the slimline switch also tends to lose its setting when the battery gets low.

If the TM751 "clicks"... then you likely have a signal sucker or line noise.