Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[eseaton]

To have the ultimate convenience for permanent or temporary installation, battery power source for cameras would be very nice.

[Brian H]

Well X10 does make one but it is not for long duration On times.
The ZB10A runs on four AA batteries and lasts about four hours.
http://kbase.x10.com/wiki/ZB10A
A heavier duty one would be nice.

[troll334]

You could do that today. You just couldn't have more than one X10 camera running at the same time on a
single channel (frequency) talking to a single video receiver. The X10 cams require powerline commands to
switch on/off allowing various cameras to be displayed in your installation; again, one at a time.

[eseaton]

How about a way to add a solar charger?

[troll334]

Oh yeah, search this forum. One of the X10 geeks here has already done it.
My wish list includes a 7Ah gel cel out in the mailbox with a 12V .1A panel feeding that.
On the inside, I'll have an appliance module to which an X10 video sender/receiver pair will connect.
That setup allows me to send the video on a channel that my three cams are not using now, and control the feed
by turning the sender/receiver pair on/off as needed (to repeat the signal on the channel I need).
The mailbox cam will always be transmitting but unless the sender/receiver pair is turned on, nothing will interfere
with the other three cams controlled by AHP and the CM15.
Oh, lots of fun.

[HA Dave]

How about a way to add a solar charger?

I ran a camera on a solar [maintenance] charged robotic device... as a way to have a mobile camera setup. The X10 cameras run well on 12 Volts DC. I used a car remote lock/starter/alarm type device to control on and off (and reduce power drain).