Please login or register.

Login with username, password and session length

Author Topic: On Alert Security Macros  (Read 9499 times)


  • Sr. Member
  • ****
  • Helpful Post Rating: 2
  • Posts: 76
On Alert Security Macros
« on: February 21, 2011, 04:35:55 PM »

When I create a macro using a security device as the trigger, the resulting .ahx file has a HC/UC assigned to the macro and it does show up when you select "Find other computers" from the "Tools" menu.  It appears that the macro with that particular HC/UC won't be triggered from a remote such as a palm pad, but should I be concerned if an actual module, such as a light/applicance/wall switch,  is assigned the same HC/UC and the security device triggers???  I'll try further testing, but I hope that someone else has gone this route.  Thanks



  • Sr. Member
  • ****
  • Helpful Post Rating: 1
  • Posts: 75
Re: On Alert Security Macros
« Reply #1 on: April 15, 2011, 02:11:59 AM »

When use security as trigger:
1. Choose "Use Adress" first, pick the same address as your sensor. Hit Enter
2. Then choose "Security" device again.

By that, u create the marcro as same adress as the security device/sensor.
I hope u know how to make ur security devices/sensor in an adress that u prefer when installed in AHP.
If not, it's best to do that. Use search in this forum.

( treat sensor as lamp or other divice, pick address, hit Enter, re-choose it as security device)
Logged | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 All rights reserved.