Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Turning off Addressable power supply to camera  (Read 2676 times)

MrTelco

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Turning off Addressable power supply to camera
« on: April 21, 2011, 01:39:28 PM »
I recently setup a camera with tilt and pan all powered by one supply but cannot shut it off.  Is there someway to use the ahp to control it???
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13308
Re: Turning off Addressable power supply to camera
« Reply #1 on: April 21, 2011, 02:04:11 PM »
The addressable power supplies are power line controlled.

If you only have one. Just send an on and off to the address it is set to.

If you have more than one. Then they work in groups of four.
Same House Code for all of them. Unit codes 1-4,5-8,9-12 and 13-16. Send an On to any in the group the other three go off.
Logged

lobuem

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 7
Re: Turning off Addressable power supply to camera
« Reply #2 on: April 21, 2011, 02:06:02 PM »
I am new also, but I was able to accomplish this with the Smart Macro plug-ins to AHP.
Logged

MrTelco

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: Turning off Addressable power supply to camera
« Reply #3 on: April 21, 2011, 09:02:01 PM »
Thanks for the info. I made up a dummy switch and addressed it the same as the power supply. It worked perfectly.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.