Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: MS12a a/c mod  (Read 2254 times)

southtoms

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 10
MS12a a/c mod
« on: May 01, 2011, 11:47:58 PM »
I'm trying to do the a/c mod. The directions say put the 10k on the left side, but the diagram shows it on the right side. Anyone know?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13308
Re: MS12a a/c mod
« Reply #1 on: May 02, 2011, 06:38:48 AM »
Physical board layouts and schematics can't be directly compared.
You will probably find the left side of the jumper wire is connected to the R10 and U1 pin 5 connection shown on the right side of the cut jumper in the schematic.

I would connect the 10K resistor where it is shown in the photo. Left physical side of the cut jumper.
« Last Edit: May 02, 2011, 06:43:09 AM by Brian H »
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.