HELP!! - Wired and Wireless Camera macro

[Barstow_Steve]

I have 2 XC18 cameras and a non x10 wired camera that AHP monitors.  Since I'm using a non x10 wired camera I use a TM751 to turn it off and on.  At the same time I'm using a second TM751 to turn off and on the wireless receiver. 

X10 wireless Camera 1 - A1
TM751 - A (turns on and off the wireless receiver)

X10 wireless Camera 2 - ??

Non X10 Camera 3 - B1
TM751 - B (turns on and off the non x10 camera)

My question is how do I get camera 2 and the TM751 that controls the receiver to turn on and off with out turning on camera 1??  Thanks in advance for any help you might offer.

[kenrad]

First you would need to set up some macros to do this and also you need to move camera 1 (a1) to a different address.  The Trancievers If set to a the total address is (A1) so the camera nad the tranciever are running on hte same address

Ken