Yes it is approx 196 degrees. The electrical bill will be just dandy.
These got me
* Turning on a SoftStart module that was dimmed before being turned off results in an Extended Dim command to the previous dim state, instead of the full 100%. In AHP, the slider momentarily goes to the previous dim state, but then goes to 100%.
(v3.310 added 4/14/2011 by Noam, confirmed still present in v3.315)
* The CM15A sends duplicate commands from timers and macros after a reboot or restart of x10nets, until AHP is opened and closed.
(added 3/23/2011 by Noam, confirmed still present in 3.315)
(ErikP 3/29/2011: Problem CAN be duplicated in testing. This is on the list to look into.)
Sense 2008 3.228 had been running my little simple setup smooth as glass for all this time. (all lamp modules are 'soft start')
At one point I bought a second cm15a to keep as backup just in case of a failure but as things grew I began using it as a all House/Unit transceiver
on the opposite phase via RF Commands and EVERYTHING worked perfect.
I discovered one could utilize security modules with an AHP update. So I bought some DS10A's and of course had and really needed to come up to speed with AHP.
That all worked out but the update(s) threw my living room lighting macro out of whack.
Anyway, the workaround I came up with was to adjust and download the macros to the second interface plugged in on that opposite phase.
Once again everything is working peachy...
