Please login or register.

Login with username, password and session length

Author Topic: wireless video sender  (Read 11128 times)

uro

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 29
wireless video sender
« on: November 07, 2011, 10:18:24 PM »

Good time ago acquired the wireless video sender and then do what the manual states failed to do that from the tv to get to control the TV remote control transmitter.

The control used is the IR18A. I can tell I'm doing wrong.

arrives at the TV video from that area reseptor but I can not change channels.

Sorry for the dramatic but not speak English.
« Last Edit: November 08, 2011, 03:38:11 PM by uro »
Logged

uro

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 29
Re: wireless video sender
« Reply #1 on: November 15, 2011, 07:32:03 AM »

Please someone can help me, and say how I can control the satellite decoder in another room using the remote control or IR18A is that this control does not work for this ...
thanks ???
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: wireless video sender
« Reply #2 on: November 15, 2011, 07:54:24 AM »

What is the part number of the Video Sender Modules?

Can you control the satellite receiver if you use the IR18A pointed directly at the receiver itself?
Logged

uro

  • Full Member
  • ***
  • Helpful Post Rating: 0
  • Posts: 29
Re: wireless video sender
« Reply #3 on: November 15, 2011, 08:26:03 AM »

Thank you.
The control is already programmed to operate in the satellite receiver, however when placing video sender, receiver can not get satellite box control of the issuer.
I have no hand video sender, but the same was acquired in the x10 page for some, months.
as control in another room while communicating with the sender, not to extend the IR Remote is not communicating with the satellite box ..
Other tests I can do ...
thanks
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: wireless video sender
« Reply #4 on: November 15, 2011, 08:41:07 AM »

Do you have the IR cable connected to the sender properly placed in front of the satellite receiver?

It would be a real big help. If you can look at the sender and receiver to get the part numbers. As X10 has recently sold a Pro version and a standard version.
« Last Edit: November 15, 2011, 10:01:45 AM by Brian H »
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: wireless video sender
« Reply #5 on: November 15, 2011, 10:14:56 AM »

Maybe an explanation of how it should work may help.

The sender unit connected to the satellite receiver. Has an IR Extender cable. It should be stuck over the satellite receivers IR sensor. Used to process a remotes commands.

The receiver unit connected to the TV you are using to watch the satellite receivers signals. Has an IR receiver in it. When you point the IR18A or the original satellite receivers remote at it. It takes the IR command and converts it to an RF signal. The RF signal is received by the sender unit and converts it back to IR. That then controlls the satellite receiver.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.